A Paper Floor - Inexpensive and it lasts and lasts!!!

Hello from St. Louis,
Yes, a paper floor lasts and lasts!!!!
 

Approximately 15 years ago, I installed a paper floor. The existing floor was "tile look alike" linoleum. At the time, I did not know, if it would last. Well it did!! Although, I do have a very high traffic home, to say the least.

Recently, I decided that it was time, to give my paper floor some TLC.

 

Shiny and it looks like New

I fell in love with one of my client's antique, wide plank floors. The next morning a box truck arrived, including a carpenter. A few hours later, I had  an antique wide plank floor in my family room. I am in love with that floor. Many compliments after,  I decided that I wanted the same floor in my kitchen.At one time, I even climbed in the dumpster to get all the left over pieces, to see if I had enough wood to lay a kitchen floor. NO WAY!!! 

Well I am a designer and a faux finisher. Wood graining came to mind. However, I did not want to spend money removing  the linoleum  floor. I decided to use plain old, cheap construction paper.

Here is what I did  fifteen years ago!

Step One:

 Cut construction paper into strips.

 

Step Two:

 

Step Three:

Thin VOV (Vinyl over Vinyl) with water and  paste the strips onto the floor. Let dry.

Step Four 

Prime. Let dry. Apply two coats of yellow. I use BM Sunbeam. 

Now that all the necessary prep work is done, you are ready to "wood grain". Don't be afraid, you are going to simulate wood and it can be done very easily.

Colors used:

Although "wood graining" seems complicated, it's actually not. It's about color and pattern. Once you understand this, you can imitate almost any wood. To make it easy for you, we just simulate an antique floor, with some knot holes and grain.

Step One:

Mix your color glazes. I mix my graining glazes with water, because I work fast. With an acrylic medium you will have a longer "open time".

Step two:

Tape off the first plank. Brush on  the raw Sienna glaze. Wipe off your 4"chip brush. Brush through the wet glaze, until you created a wood-grain effect.Start at one end of the plank, and keep going in a continuous motion to the end of the plank.Continue stroke after stroke.

 

Keep wiping your brush. Let Dry. Care fully pick up some burnt Sienna glaze and create some additional values. Soften with a clean chip brush. Let dry. Add additional darks ( burnt Sienna and Black). Once you are satisfied with the grain, you may add some knotholes and or additional graining.

Now that my floor is completed, I decided to re-vamp my whole home. Is that OCD??? No, it's because of the long winter!!!

Take care and be safe sending blessings your way,

Fondly,

 

Read More